For MT inspection equipment we go beyond the basic calibration with our 48 pt inspection of all essential systems which also includes a report detailing the condition of the unit. After inspection, a thorough Preventative Maintenance is performed. During the PM we will clean contacts, tighten screws, and replace worn components, restoring your machine to just like when you first got it – or better!

48 pt Inspections Include:

  • Primary Electrical
  • Pneumatic
  • Particle Bath
  • Plumbing
  • Control Panel
  • Secondary Electrical
  • Component inspection
  • Accessories Check
  • Operator Interface assessment

NTC Service/Calibration features but not limited to:

  • Magnetic Particle Machine- Stationary, Mobile, & Portable
  • Pressure Gauges up to 15,000 PSI
  • Temp Guages
  • Penetrant Dryers
  • Contour Probes
  • Hall Effect Probes
  • Gauss meters
  • Densitometers
  • Conductivity Meters
  • Light Meters
  • Bond Testers
  • UT Thickness
  • UT Flaw
  • Phased-Array (Conventional UT mode only)
  • ET Instruments
  • Shot Timers

UtAvailability:

  • In-House Lab
  • On-Site, Same day Calibration
  • Mobile Calibration Unit

Certified to:

NCSL Z540

ALL CALIBRATION IS DONE WITH EQUIPMENT AND STANDARDS TRACEABLE TO  CURRENT NIST CERTIFICATIONS.

ISO– Compliant (I.E.: ISO-17025, ETC.)

Please note that all calibrations are performed in accordance with the original manufacturer’s specifications, and/or procedure #NTC-CP201, utilizing test standards traceable to the National Institute of Standards and Technology.  Our calibration system complies with ASTM 317, 709, 1444, MIL-STD 45662A*, ISO 10012-1, ANSI/NCSL-Z540-3-2006, 10 CFR 21, and 10 CFR 50 Appendix B.  All certification data sheets completed will be on file at North Texas Calibration, Inc.

Rapid Turnaround

We offer rapid turnaround times as quick as 24-48 hours! Let's schedule an appointment and get the process started.

Schedule Now